Minzheng Jiang
Engineering · The Ohio State University
Publications
58
Citations
507
Est. group size
~2
Recurring co-author estimate
Active years
31
Publishing since 1996
Minzheng Jiang works on engineering problems related to oil and gas production, including pumping systems, hydraulic fracturing, wax and crude oil behavior, and downhole equipment fault diagnosis. The research also extends into additive manufacturing (3D printing with materials like biomass composites) and mechanical systems such as pumps and hydrocyclones, often using simulation, experimental testing, and diagnostic modeling methods.
Publication output has fluctuated over the last decade, peaking around 2020-2021 and 2023, with lower counts in other years, suggesting an uneven but ongoing publication cadence rather than a clear steady increase or decline.
Generated by claude-sonnet-5 from public bibliographic data · Jul 20, 2026
- A study on yield calculation method using suspension power chart in beam pumping systems
Journal of Physics Conference Series · 2024
- Diagnosing injection-production system faults in the same well using the rough set-LVQ neural network
PLoS ONE · 2023
- Cutting Experiment of Fraxinus mandshurica Using Waterjet-Assisted CO2 Laser
JOURNAL OF RENEWABLE MATERIALS · 2023
- Study on the Powder-Spreading Process of Walnut Shell/Co-PES Biomass Composite Powder in Additive Manufacturing
Materials · 2023
- Study of Forming Performance and Characterization of DLP 3D Printed Parts
Materials · 2023
- Effect of mechanical stirring on the tubular heating process of crude oil
International Journal of Heat and Mass Transfer · 2023
- Seismic random noise suppression by using MSRD-GAN
Geoenergy Science and Engineering · 2023
- Influence of Horizontal Multi-Bedding on Hydraulic Fracture Propagation in Shale Reservoirs
Processes · 2023
- The Numerical Simulation of the Pressure Law and Control of the Hard Roof Face in the Far Field
Sustainability · 2023
- Research on working condition diagnosis method of downhole oil-water separation system with sucker-rod pump
Advances in Mechanical Engineering · 2023
- Influence of Axial Position of Self-Circulating Casing Treatment on the Performances of a Centrifugal Pump at Low Mass Flow Conditions
Journal of Applied Fluid Mechanics · 2022
- Simulation Analysis of Stress Field of Walnut Shell Composite Powder in Laser Additive Manufacturing Forming
JOURNAL OF RENEWABLE MATERIALS · 2022
- Enhanced Adhesion—Efficient Demolding Integration DLP 3D Printing Device
Applied Sciences · 2022
- Submersible Screw Pump Fault Diagnosis Method Based on a Probabilistic Neural Network
DOAJ (DOAJ: Directory of Open Access Journals) · 2022
- Design and laboratory test of small diameter submersible pump
International Conference on Intelligent Equipment and Special Robots (ICIESR 2021) · 2021
- Materials×3
- PLoS ONE×3
- JOURNAL OF RENEWABLE MATERIALS×3
- IEEE Transactions on Applied Superconductivity×3
- Ceramics International×2
- Erdal Özkan
Engineering · The Ohio State University
- Yiwen Gong
Engineering · The Ohio State University
- Ilham El‐Monier
Engineering · The Ohio State University
- Yu Ding
Engineering · The Ohio State University
- Manoj Choudhary
Engineering · The Ohio State University
This profile was generated automatically from public scholarly data (OpenAlex). Group size and activity levels are estimates derived from co-authorship patterns.
Last updated Jul 19, 2026.
Claim or correct this profile